The wheel shows up under Control Panel > Devices and Printers (amusingly, under Properties, the Manufacturer's name is 'unavailable'!!!) The hardware shows up as both an 'HID-compliant game controller' and a 'USB Input Device' I didn't need to install any drivers I just plugged in the wheel's power supply and the wheel into the I was both surprised and delighted to find that my Sidewinder USB Force Feedback Wheel works PERFECTLY with Codemasters F1 2010 under Windows 7 64bit. Anyway, works great here, it might be a solution for any of you as well.
I tested it with F1 Racing after I did the calibration procedure in this game as well, and it worked pretty good. When testing it after the calibration procedure in Windows 7 it showed the marker right in the middle, pressing accelerate would movie it up, pressing breaks would move it down. Not a big issue, just something that needs to be done every time. Then I made parallel wires between the two potentiometers (since the are facing to one another the outside pins are crossed) First important thing is that the break pedal needs to be pressed before and while the USB cable is plugged in, the unit seems to calibrate itself also and it needs this.
I opened the pedals and fould two simple potentiometers. Dual boot would have been an option as well but it's sort of a pain in the butt to switch over all the time. XP was not an option since I run Windows 7 for a while now and have good experience with that. So after reading lots on websites about this issue I realized that I had to use it on XP or find another solution. Some said it works under Windows7, but were not clear if the pedals work fine and if they used any specific driver. I had the same issue when I decided to use it again with my son to play Formula 1 Racing.
0 kommentar(er)
